QUESTION 104
An engineer sets up a DMVPN connection to connect branch 1 and branch 2 to HQ branch 1 and branch 2 cannot communicate with each other. Which change must be made to resolve this issue?

QUESTION 105
Refer to the exhibit.

An engineer implemented CoPP but did not see OSPF traffic going through it. Which configuration resolves the issue?

QUESTION 106

Refer to the exhibit. An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2. Which debug command is used to troubleshoot this issue?

QUESTION 107
The network administrator configured CoPP so that all routing protocol traffic toward the router CPU is limited to 1 mbps. All traffic that exceeds this limit must be dropped. The router is running BGP and OSPF Management traffic for Telnet and SSH must be limited to 500kbps.
access-list 100 permit tcp any any eq 179
access-list 100 permit tcp any any range 22 23
access-list 100 permit ospf any any
!
class-map CM-ROUTING
match access-group 100
class-map CM-MGMT
match access-group 100
!
policy-map PM-COPP
class CM-ROUTING
police 1000000 conform-action transmit
class CM-MGMT
police 500000 conform-action transmit
!
control-plane
service-policy output PM-COPP
No traffic is filtering through CoPP,which is resulting in high CPU utilization,which configuration resolves the issue ?

QUESTION 108
Refer to the exhibit.

An IT staff member comes into the office during normal office hours and cannot access devices through SSH Which action should be taken to resolve this issue?

QUESTION 109
Refer to the exhibit.

An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed. What is the reason for this issue?

QUESTION 110
Drag and drop the MPLS VPN device types from me left onto the definitions on the right.

QUESTION 111
A network administrator is troubleshooting a high utilization issue on the route processor of a router that was reported by NMS The administrator logged into the router to check the control plane policing and observed that the BGP process is dropping a high number of routing packets and causing thousands of routes to recalculate frequently. Which solution resolves this issue?

QUESTION 112
An engineer is implementing a coordinated change with a server team. As part of the change, the engineer must configure interlace GigabitEthernet2 in an existing VRF “RED” then move the interface to an existing VRF “BLUE” when the server team is ready. The engineer configured interface GigabitEthemet2 in VRF “RED”

Which configuration completes the change?

QUESTION 113
Refer to the exhibit.

A user cannot SSH to the router. What action must be taken to resolve this issue?

QUESTION 114
How does an MPLS Layer 3 VPN function?

QUESTION 115
What is a function of an end device configured with DHCPv6 guard?

QUESTION 116
Refer to the exhibit.

Drag and drop the credentials from the left onto the remote login information on the right to resolve a failed login attempt to vtys. Not all credentials are uf SLA by defining frequency and schedulingsed

QUESTION 117
In which two ways does the IPv6 First-Hop Security Binding Table operate? (Choose two.)

QUESTION 118
Refer to the exhibit.
An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?
A)

B)

C)

D)

QUESTION 119
Refer to the exhibit.

The R1 and R2 configurations are:

The neighbor is not coming up. Which two sets of configurations bring the neighbors up? (Choose two.)

QUESTION 120
Refer to the exhibit.

R1 is being monitored using SNMP and monitoring devices are getting only partial information. What action should be taken to resolve this issue?

QUESTION 121
Refer to the exhibit.

The security department recently installed a monitoring device between routers R3 and R5, which a loss of network connectivity for users connected to R5. Troubleshooting revealed that the monitoring device cannot forward multicast packets. The team already updated R5 with the correct configuration. Which configuration must be implemented on R3 to resolve the problem by ensuring R3 as the DR for the R3-R5 segment?
A)

B)

C)

D)

QUESTION 122
Which statement about route distinguishers in an MPLS network is true?