Huawei H12-811_V1.0 Premium Exam Engine pdf – Download Free Updated 701 Questions [Q212-Q233]

4.2/5 - (4 votes)

Huawei H12-811_V1.0 Premium Exam Engine pdf – Download Free Updated 701 Questions

Verified H12-811_V1.0 Bundle Real Exam Dumps PDF

NO.212 The output information of the router R1 routing table is shown in the figure. Which of the following statements is correct?

The router will forward data packets whose destination network is 12.0.0.0/8

The data packet whose destination network is 12.0.0.0/8 will be forwarded from the router’s Ethernet0/0/0 interface

The router will discard packets whose destination network is 11.0.0.0/8

The data packet whose destination network is 11.0.0.0/8 will be forwarded from the router’s Gigabitethernet0/0/0 interface

NO.213 In order to realize the network layer function on the VLANIF interface, it is necessary to configure on the VIANIF interface?

IP address

IP prefix

Subnet mask

MAC address

NO.214 The login timeout time in the VRP system can only be set under the vty interface. ()

True

False

NO.215 In the broadcast network, which routers will a DRother router exchange link status information with?

DR Other

BDR

All ospf neighbors

NO.216 On an interface that uses PPP as the data link layer protocol, you can configure a static route by specifying the next hop address or outgoing interface. ()

True

False

NO.217 What are the advantages of using dynamic host configuration protocol DHCP to assign IP addresses?

Avoid IP address conflicts

Reuse of IP address can be realized

When the configuration information changes (such as DNS), only the administrator needs to modify it on the DHCP server, which is convenient for unified management

Heavy workload and poor management

NO.218 The IP addresses of the VLANIF interfaces of the same switch cannot be the same. ()

True

False

NO.219 VRP does not support how to configure the router?

Configure the router through the Console port

Configure the router via FTP

Configure the router through the mini USB port

Configure the router via Telnet

NO.220 When deploying ACL on Huawei equipment, which of the following descriptions is correct is ().*

ACL can match the TCP/UDP port number of the packet, and can specify the range of port numbers

The same ACL can be called under multiple interfaces

When ACL defines rules, it can only proceed in the order of 10, 20, 30

ACL cannot be used to filter OSPF traffic, because OSPF traffic does not use UDP protocol encapsulation

When calling ACL under the interface, it can only be applied to the outbound direction

NO.221 Which bridge ID is unlikely to appear in the configuration BPDU sent by the switch?

2048 00-01-02-03-04-CC

8192 00-01-02-03-04-CC

4096 00-01-02-03-04-CC

0 00-01-02-03-04-CC

NO.222 Telnet is based on TCP protocol.

True

False

NO.223 On Huawei ARG3 routers, the -i parameter of the Ping command in VRP is used to set ().

Destination IP address for receiving Echo Reply reply

The source IP address of the Echo Request message

Interface for receiving Echo Reply messages

Interface for sending Echo Request messages

NO.224 Regarding the configuration shown in the figure, which statement is correct? () (Single-choice question)

history-command max-size20 is to adjust the size of the history named cache to 20

The default size of the history command cache is 5 bytes

After the above configuration is completed, the history command buffer can store 20 bytes of commands

The default size of the history command cache is 5

NO.225 As shown in the figure, the network administrator creates VLAN2 on the SWA and SWB, and configures the ports connecting the hosts on the two switches as Access ports and assigns them to VLAN2.
Configure G0/0/1 of SWA and G0/0/2 of SWB as trunk ports to allow all VLANs to pass. To achieve normal communication between the two hosts, you also need.

Configure G0/0/1 on SWC as a trunk port and allow VLAN2 to pass through, set G0/0/2 as an access port, and set the PVID to 2.

Create VLAN2 on SWC, configure G0/0/1 and G0/0/2 as trunk ports, and allow VLAN2 to pass

Create VLAN2 on SWC

Configure the G0/0/1 Trunk port on SWC and allow VLAN2 to pass through

NO.226 The two switches shown in the figure below have both enabled the STP protocol. An engineer made the following conclusions on this network. Which conclusion do you think is correct?

The G0/0/3 port of SWA is stable in Forwarding state

The G0/0/2 vertical port of SWB is stable in Forwarding state

Both ports of SWA are designated this port

The G0/0/2 port of SWA is stable in the Forwarding state

NO.227 Which of the following working modes does Huawei Enterprise AP support?

Local

CLoud

FAT

FIT

NO.228 As shown in the figure, the switch runs STP with default parameters. Which of the following ports will be elected as the designated port? () (Single-choice question)

Port G0/0/1 of switch A

HUB’s G0/0/1 port

HUB’s G0/0/2 port

Port G0/0/2 of switch A

NO.229 If the administrator wants to update the VRP version of Huawei routers, the correct method is ().

The administrator configures the router as a TFTP client and transmits VRP software through TFTP

The administrator configures the router as an FTP server and transfers the VRP software through FTP

The administrator configures the router as an FTP client and transfers the VRP software through FTP

The administrator configures the router as a TFTP server and transmits VRP software through TFTP

NO.230 The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)