Dumps of H12-811-ENU Cover all the requirements of the Real Exam [Q175-Q194]

4/5 - (1 vote)

Dumps of H12-811-ENU Cover all the requirements of the Real Exam

Correct Practice Tests of H12-811-ENU Dumps with Practice Exam

NEW QUESTION 175
When planning the campus network, which of the following mask lengths is recommended for device interconnection IP addresses?

NEW QUESTION 176
Which of the following functions does the LCP protocol in the PPP protocol support?

Negotiate network layer address

Negotiate authentication agreement

Detect link loops

Negotiate the maximum receiving unit MRU

NEW QUESTION 177
The following two configuration commands can realize the router RTA to the same destination 10.1.1.0 routing master and backup backup.
【 RTA 】 ip route-static 10.1.1.0 24 12.1.1.1 permanent
【 RTA 】 ip route-static 10.2.2.0 24 13.1.1.1.

True

False

NEW QUESTION 178
In the STP protocol, which of the following factors will affect the election of the root switch? (Multiple choice)

The IP address of the switch

Switch interface ID

Switch interface bandwidth port

Switch priority

MAC address of the switch

NEW QUESTION 179
Virtualization is the basis for the realization of NEV. Which of the following statements about the characteristics of virtualization is correct? (Multiple choice)

Hardware independence: virtual machine and hardware decoupling, support virtual machine migration between servers.

Encapsulation: All virtual machines share the operating system, and encapsulation is achieved through name spaces.

Isolation: The virtual machines on the same physical server are isolated from each other.

Partition: You can run multiple virtual machines on a single physical server at the same time.

NEW QUESTION 180
In what state does the OSPF protocol determine the master-slave relationship of DD packets?

ExStart

Full

2-way

Exchange

NEW QUESTION 181
The output information of the link aggregation port of a certain switch is as follows. If you want to delete Eth-Trunk 1, which of the following commands is correct?

undo interface Eth-trunk 1

inte GigabitEthernet 0./0/2 Undo eth-trunk Quit Undo interface eth-trunk 1

inte GigabitEthernet 0./0/1 Undo eth-trunk Quit inte GigabitEthernet 0./0/2 Undo eth-trunk Quit

inte GigabitEthernet 0./0/1 Undo eth-trunk Quit Undo interface eth-trunk 1

NEW QUESTION 182
Which of the following IPv4 addresses the host uses cannot directly access the Internet?

100.1.1.1

50.1.1.1

10.1.1.1

200.1.1.1

NEW QUESTION 183
The network shown below, it is desirable host traffic network administrator during planning A destined for host B data packets through the router between the G0/0/3 interfaces, the host B to the host PC A data packet through the router Between the G0/0/4 interface, which of the following commands can achieve this requirement? (Multiple choice)

RTA : ip route-static 10.0.12.5 255.255.255.252 11.0.12.2 RTB : ip route-static 10.0.12.1 255.255.255.252 11.0.12.5

RTA : ip route-static 10.0.12.5 255.255.255.252 11.0.12.6 RTB : ip route-static 10.0.12.1 255.255.255.252 11.0.12.1

RTA : ip route-static 0.0.0.0 0.0.0.0 11.0.12.2 RTB : ip route-static 0.0.0.0 0.0.0.0 11.0.12.5

RTA : ip route-static 0.0.0.0 0.0.0.0 11.0.12.6 RTB : ip route-static 0.0.0.0 0.0.0.0 11.0.12.1

NEW QUESTION 184
When the LACP mode is used for link aggregation, what is the default system interference level of Huawei switches?

36864

4096

24576

32768

NEW QUESTION 185
What is the priority value of the direct route entry?

NEW QUESTION 186
Which of the following statements about Adjacency Segment is wrong?

Adjacency Segment is identified by Adjacency Segment ID (SID)

Adjacency Segment spreads to other network elements through IGP protocol, which is visible globally and effective locally

Adjacency Segment must be configured manually

Adjacency Segment is used to identify an adjacency of a node in the network

NEW QUESTION 187
What is the destination IP address of the DHCP DISCOER message?

127.0.0.1

224.0.0.1

224.0.0.2

255.255.255.255

NEW QUESTION 188
Which of the following packet types is used by RADIUS to indicate authentication rejection?

Access-Accept

Access-Request

Access-Challenge

Access-Reject

NEW QUESTION 189
A device has been configured to complete the Telnet configuration. The device login address is 10.1.1.10. The Telnet user name is admin and the password is Huawei@123. Which of the following is the correct way to log in to this device using telnetlib?

telnetlib.Telnet （ 10.1.1.0,23,admin,Huawei@123 )

telnetlib.Telnet （ 10.1.1.0 )

telnetlib.Telnet （ 10.1.1.0,23, Huawei@123 )

telnetlib.Telnet （ 10.1.1.0,admin )

NEW QUESTION 190
SNMPv1 defines 5 protocol operations.

True

False

NEW QUESTION 191
If the broadcast address of a network is 172.16.1.255, then what may its network address be?

172.16.1.128

172.16.2.0

172.16.1.1

172.86.1.253

NEW QUESTION 192
In the CAPWAP tunnel establishment phase, after the AC receives the Join Request message sent by the AP, the AC will check the validity of the AP. Which of the following is the authentication method supported by the AC? (Multiple choice)

SN certification

Password authentication

MAC authentication

Not certified

NEW QUESTION 193
vty configuration as shown in the figure, the user authority level is set to level 3.
[Huawei]user-interface vty o 14
[Huawei-ul-vtyo-14]acl 200o inbound
[Huavei-ui-vtyo-14]user privilege level 3
[Huavei-ui-vtyo-14]authentication-node password Please configure the login password (maxim length 16):huawei

False

True

NEW QUESTION 194
After the system restarts the static MAC address table, the saved entries will not be lost.

TRUE

FALSE

Loading …